Get a super price on these Spill Proof Funnels. Very limited stock these pay for themselves with the first use!.
Features:
Made from PP ECO material.
Fit Radiators or Surge Tanks on most Domestic and Import Cars and Light Trucks.
Minimise coolant spills onto your workshop or garage floor using this filling kit.
Well sealed interface funnel design, allows a quick visual check of the coolant.
The Innovative bleeding kit controls the coolant entering system and enables unattended filling.
Eliminates trapped air pockets which may cause instability in the cooling system and heater.
The Fluid Stopper will help you economically recycle unused coolant in the funnel after finish. Bright colour and sealed lid help you to storage efficiently.
Kit Contents.
1 x Lid
1 x Funnel
2 x 45 Degree Elbow
1 x Fluid Stopper
1 x Large Cap A
1 x Medium Cap B
1 x Small Cap C
1 x Threaded Cap D
1 x Small Adapter C with Gasket
1 x Large Adapter A with Gasket
1 x Medium Adapter B with Gasket
1 x 5 inches Straight Extension
1 x Threaded Cap Adapter E with Gasket
1 x Threaded Cap Adapter D with Gasket for GM
Instructions
First install the correct sized adapter into the correct cap. Place the gasket in a downward position.
Tighten the cap with adaptor to make sure it doesn’t leak.
If 45° elbow or extension needed, place the funnel after elbow or extension is placed well into the adapter opening.
Fill funnel slowly and carefully with coolant about 1/3 full.
When run the engine with funnel attached, fluid level should be at low position.
Keep RPM on idle position. (Shut down the engine if notice the fluid level rise excessively. Wait for fluid level go lower before restarting the engine.)
Use Fluid Stopper for remaining fluid inside the funnel to flow to the radiator hose by squeeze it and release.
After finish, remove the funnel (and or extension/elbow) & adapter, close the radiator with cap tightly.
